Home > Knowledge > Content

Chainsaw start method and chain saw guide specifications

- Nov 24, 2017 -

How to start the chain saw?

The fuel tank filled with a good ratio of the fuel mixture ratio FB / FC level 1: 25 oil, FD level oil 1:50. Chain tank filled with clean chain lubricants or oil. Will turn off the switch hit the "I" position. Pull the brake baffle to the outside to close the brake. Open the door. Pull start pull rope. After starting the reaction, close the damper pull the start rope. Pull the brake baffle inward to turn on the brake. After the start is completed, the throttle trigger is pulled to reset the throttle to idle position. Cycle to accelerate the heat engine. At the same time the guide toward the ground, check the chain saw chain oil should be sprayed during operation. The first 10 hours, the oil mixture slightly thicker, after the normal ratio.

Chain saw guide specifications

Guide there are many specifications, depending on the specific product model, corresponding to the corresponding chain and guide parameters, the guide is more with 20-inch, 18-inch, and 16-inch, 14-inch. These small models of the guide plate are laminated guide, the larger chain saw guide 30-inch, 36-inch, 42-inch, but these are basically Korean alloy guide. See your chain saw model.


Related Industry Knowledge

Related Products

  • Craftsman 40cc Gas Chain Saw
  • 40cc Forest Operation Gas Chain Saw
  • 58cc Best Petrol Chainsaw
  • Smart Oregon Chainsaw
  • Homemade Oregon Chainsaw 58cc
  • Showbull 58cc Oregon Chainsaw