Home > Knowledge > Content

Common failures and troubleshooting of oil saw

- Oct 24, 2018 -

Common failures and troubleshooting of oil saw
1. If the oil saw turns off, works less vigorously, and the generator overheats, etc
It's usually the filter.
So before working, need to be checked to filter, clean and eligible filter is aimed at the sunlight to observe, should be thorough, bright, otherwise is unqualified.
When the filter of oil saw is not clean enough, use hot soapy water to clean and dry.
Clean filter can ensure the normal use of the saw.
Common failures, troubleshooting methods and matters needing attention of the saw

002

2. When the saw's saw teeth become not sharp

You can use a special file to repair the serrated chain teeth to ensure the sharpness of the serrated teeth.
At this time, it should be noted that the direction of the file, along the cutting teeth, do not reverse, and file and oil saw chain chain Angle should not be too large, 30 degrees is appropriate.
3. Before using the oil saw, the oil of the chain saw should be added. The advantage of this method is that it can provide lubrication for the oil saw, reduce the friction heat between the chain of the oil saw and the guide plate of the oil saw, play a protective role for the guide plate, and also protect the chain of the oil saw from premature scrapping.
4. After the use of the saw, the saw should be maintained, so that the working efficiency can be guaranteed when the saw is used again.
The first thing is to remove impurities from the inlet hole and the groove of the guide plate of the oil saw to ensure a smooth inlet hole.
Next also should clear to guide board head inside sundry, add a few drop machine oil.
5. The oil saw cannot start
Check whether there is water in the fuel or use unqualified mixed oil, and replace the appropriate fuel.
Check if there is water in the engine cylinder. Solution: remove and dry the spark plug and pull the starter again.

Check spark strength. Solution: replace spark plug or adjust motor ignition gap.

014

6. Underpower of oil saw
Check whether there is water in the fuel or use unqualified mixed oil, and replace the appropriate fuel.
Check whether the air filter and fuel filter are blocked and clear.
Check if the carburetor is not properly adjusted, solution: re-adjust the carburetor of the saw.
You can't saw the oil out
Check whether there is oil that does not meet the specification, change the oil.
Check whether the oil channel and orifice are blocked and clear.
Check whether the oil filter head in the oil tank is properly placed. The excessive bending of the oil pipe leads to the oil road blockage or blockage of oil filter head.
Solution: place as required to ensure normal oil absorption.

Quote from:www.toutiao.com

Related Industry Knowledge

Related Products

  • Best 35.8cc High Quality Brush Cutter
  • Valued Steel Chain Saw
  • Hand Grass Cutting Machine With Good Performance
  • Pocket Gas Chain Saw
  • Gas Chainsaw Outdoor Power Equipment
  • 40cc Oregon Chainsaw