Common trouble of saw and solution
Long - term use of the saw or maintenance is not in place to avoid failure.
What did everyone do when the saw failed?
Today we are going to tell you a few common problems of the saw and solutions.
1. The oil saw cannot start
Check whether there is water in the fuel or use the wrong mixture.
Solution: replace the appropriate fuel.
Check the engine cylinder for water.
Solution: remove and dry the spark plug and pull the starter again.
Check spark strength.
Solution: replace the spark plug or adjust the ignition gap of the motor.
2. Underpower of oil saw
Check whether there is water in the fuel or use the wrong mixture.
Solution: replace the appropriate fuel.
Check air and fuel filters for blockages.
Solution: clear.
Check the carburetor for improper adjustment.
Solution: readjust the saw carburetor.
3. No oil can be seen from the oil
Check if there is any oil that does not meet the specification.
Solution: replace the oil.
Check the oil channel and orifice for obstruction.
Solution: clear.
Check whether the oil filter head in the oil tank is properly placed. The excessive bending of the oil pipe leads to the oil road blockage or blockage of oil filter head.
Solution: place as required to ensure normal oil absorption.
Quote from:www.toutiao.com
Previous: The saw turned off at high temperature