Home > Knowledge > Content

How to replace the chainsaw start rope?How to judge the cylinder phenomenon of chainsaw engine?

- Apr 07, 2018 -

How to replace the chainsaw start rope?How to judge the cylinder phenomenon of chainsaw engine?

Chain saw is a kind of garden machinery used for the cutting trees, because a lot of the tendrils of trees is various, sometimes leads to other ground vegetation in the garden can't get enough sun exposure, and redundant tendrils can touch other trees, affect beautiful, so in order to shed excess tendrils, chain saw come in handy, but generally short guide chain saw used for intermittent branch pruning, long guide chain saw for cutting trees.Everyone will encounter in the process of using the chain saw chain saw start rope don't know how to change, I don't know how to judge the chain saw phenomenon of engine cylinder, small make up just want to say to you today.

How to replace the chainsaw start rope?

Replacing start rope, the rope round the fixed screw loose on the first, take the rope round (be careful not to make scattered the coil spring, and then pulled down the old rope, then put one end of the rope from the rope through the round hole, on the other side from the pull handle, fixed, fixed rope round, again drag rope clockwise card in the small openings on the rope round began to turn, turn to the coil spring is tight.

What if the chainsaw pulls the rope?

It may be the disc spring card in the chainsaw starter, easy to start is two coil springs, single start is a coil spring, pull line pull not to come out should be the disc spring card to die.When repairing, remove the starter, check the coil spring, and replace a new one.
DSC_2549.JPG

How to replace the chainsaw start rope?How to judge the cylinder phenomenon of chainsaw engine?

What part is the problem with the chainsaw?

The air filter of the chainsaw can filter the dirt and other foreign material, prevent the foreign body from entering the cylinder, causing the bad accident of the cylinder.When the chainsaw is out of fire, the work is weak, and the engine is overheating, it may be that the air filter is dirty and needs to be maintained.Clean air filter should be checked before work, qualified air filter on the sunlight observation, should be clear and bright, not qualified on the air filter is full of wood slag, dust, touch feel thick hard, hot, soapy water cleaning, dry at this time.Clean, transparent, soft air filter can ensure the normal operation of the chainsaw.

How to judge the cylinder phenomenon of chainsaw engine?

The cylinder of the chainsaw is killed by the cylinder, so long as the piston is checked, there are several reasons:

1. There is serious carbon deposition on the top of the piston and around the ring.

It is mainly caused by the use of bad oil, such as the use of wood oil or inferior two-stroke engine oil.

2. The exhaust side cylinder of the chainsaw piston.

Chain saw air filter impurity, junk clogging carburetor fuel, adjustment is too small or too little fuel oil to join in, cut into the cylinder gas concentration, such as paper pad insulator leakage and insufficient lubrication, easy to pull cylinder caused by high temperature.

3. The inlet of the chainsaw piston is pulled down.

Is basically into the water, like a snow use, such as water from the chain saw air filter into the cylinder, so that the lubricating oil film is water mix, make chain saw piston under the suction side of the side lack of lubricating oil film, after high speed, heating cylinder.

4. Inlet side pull cylinder of chainsaw piston.

Because the air filter is in the garbage, you must clean the air filter regularly to prevent the foreign body from entering the cylinder.

Above is about the chain saw how to change the start rope, chain saw weakness and how to determine the cause of the phenomenon of chain saw cylinder, which you can follow the instructions in the case of emergency repairs, not professional maintenance must be sent to the service center for repair.

Quote from:www.toutiao.com

Related Industry Knowledge

Related Products

  • 31CC Portable Brush Cutter
  • Showbull 40cc Gas Chain Saw
  • 22 Gas Petrol Chainsaw 60cc
  • Sprinkler Head Sod Gas Brush Cutter
  • Big Power Petrol Brush Cutter
  • Lightweight Green Hedge Trimmer