Home > Knowledge > Content

How to solve the heat problem of oil saw guide plate and chain?

- Nov 08, 2018 -

How to solve the heat problem of oil saw guide plate and chain?

When the guide plate of the oil saw is used, it is hot or even hot.
When the oil saw is working, what reason is the temperature of the guide board too high to get hot or hot?
As the driving medium of passive disk and chain, the chain sprocket is often replaced due to its high working intensity and high loss.
Heating problem of oil saw guide plate and chain
The most fundamental cause of the heating problem is excessive friction. The oil saw itself has a lubricating oil supply system. Therefore, the abnormal operation of the oil supply system is often the cause of heating the oil guide plate of the oil saw.
If the oil pipe is damaged or leaking, the oil filter head is blocked, the oil pump is blocked, the oil nozzle of the oil pump is not flat, the paper pad of the oil nozzle of the oil pump is damaged, the oil hole of the guide plate is blocked, and so on, all of these circumstances cause the abnormal oil supply.

4000

Here are several possible causes and solutions for heating of the guide plate and chain of the oil saw:
1. Insufficient oil supply or no oil
Solution: add oil in time to clear the oil supply circuit, such as oil filter head, oil pump, oil pipe.
Among them, the bottom of the oil pump can be adjusted with a word of rose cutter.
2. Oil hole of guide plate is blocked or channel is blocked
Solution: use a blowgun to clean wood chips or debris off the guide.
3. The width of guide plate slot does not match the width of chain guide teeth
Solution: it is recommended to change to the matching specification.
4. Uneven bending of guide plate
Solution: direct replacement of the guide plate is recommended.
Other notes:
Although the lube used between the guide plate of the oil saw and the chain is not too high, the waste engine oil can also be replaced by the general engine, but the oil needs to be filtered before use, so as not to cause obstruction.
Do not adjust too tight or loose the guide plate and chain of the saw. It is required that the chain should be close to the guide plate after installation, and the chain can be pushed freely when it is pushed forward with the rose knife.
When the chain is pulled away from the guide plate after the chain is installed, about half of the guide teeth can be pulled up.
Cripp oil saw with imported orrigan chain
Note that the slotted width of guide plate corresponds to the thickness of guide teeth of chain. Under normal circumstances, the thickness of guide teeth of 325 is 1.5mm, while most of the larger 3/8 is 1.6mm.

Buy qualified guide board, good quality guide board quality is more hard wear-resisting commonly, and guide board is flat, won't have bend phenomenon.
The corep guide board is recommended here.

DSC_2552

Quote from:www.toutiao.com

Related Industry Knowledge

Related Products

  • 25cc Gas Chain Saw
  • The Ultimate Garden Machine 31CC Petrol Brushcutter
  • 58cc Ranch & Farm Gas Chainsaw
  • Small Gas Hedge Trimmer
  • Lightweight CS2500 Oregon Chainsaw
  • Oregon Chainsaw CS5800