Home > Knowledge > Content

Maintenance of all parts of the mower

- Oct 30, 2018 -

Maintenance of all parts of the mower

BG3602可以用

I. engine
When the engine is a two-stroke engine, the fuel oil is mixed with oil, and the blending oil ratio is: two-stroke special engine oil: gasoline = 1:25.
Please strictly follow the oil pot supplied with the machine, and do not mix oil as estimated.
Mix oil is best now match now use, forbid to use match the mix oil that buy for a long time.
The machine should run at low speed for a few minutes before working.
When the machine is working, the throttle can be used normally at high speed.
After working one tank of oil, take a rest for 10 minutes and clean the heat sink of the machine after each work to ensure the heat dissipation.
The spark plug shall be removed every 25 hours. The dust on the electrode shall be removed with a wire brush, and the gap of the electrode shall be adjusted to 0.6-0.7mm.
Dust should be removed from the air filter every 25 hours.
The cleaning of foam filter adopts gasoline or washing liquid and water to clean, squeeze and dry, then soak the oil and remove the excess oil.
"DON NOT OIL" is NOT used.
Every 50 hours, remove the muffler and clean the carbon deposition on the vent and muffler outlet.
The fuel filter (oil suction head) removes impurities every 25 hours.
How to do the winter maintenance of mower?

02

2.The transmission part

Replenish grease to the reducer (working head) every 25 hours, and add grease to the upper part of the drive shaft to the junction of the clutch plate.
3.The cutter part
The length of the nylon cable should be controlled, not more than 15 cm.
The blade must be fitted properly and balanced.
4.Safety in use
Check whether all parts of the mower are installed firmly, within 20 meters around, and no human or animal is allowed to walk around.
Be sure to check if there is any Angle iron, stones and other debris on the lawn.
5, storage
When stored, the body must be cleaned, the mixed fuel discharged and the fuel in the carburetor burned.
Remove the spark plug, add 1-2ml 2 stroke oil into the cylinder, pull the starter 2-3 times, and install the spark plug.
6. Matters needing attention for filling oil
Oil in the cylinder lubrication of mechanical parts, is through the oil splash, constantly put oil splash, parts of mechanical cleaning, lubrication, cooling, if too much filling oil may cause a lot of emulsification and bubble, also cannot put oil splash, which cannot have the effect of lubrication, by raising the temperature of the cylinder block.
Therefore, the mower should not add too much oil during operation.

Quote from:www.toutiao.com

Related Industry Knowledge

Related Products

  • 16 In. 40cc 2-Cycle Gas Chainsaw
  • Small Gas Garden Chain Saw
  • Craftsman 4010 Gas Chain Saw
  • Professional 20 Inch Petrol Chainsaw
  • Pocket Oregon Chainsaw with 25cc
  • Showbull 58cc Oregon Chainsaw