Several problems occurred in the use of saw
1. In case of oil saw, it is usually the problem of filter when the oil saw is put off, it is not so exciting to work, and the heat generator is overheated.
Therefore, before work, the filter needs to be checked, the clean qualified filter should be pointed at the sunlight observation, should be thorough, bright, otherwise is not qualified.
When the filter of oil saw is not clean enough, use hot soapy water to clean and dry.
A clean filter will ensure the proper use of the saw.
2. When the saw's serrated teeth become not sharp, you can use a special file to rest the serrated chain teeth to ensure the sharpness of the saw teeth.
At this time, it is important to note that when using file, the direction of the cutting teeth should be down, not the reverse, and file and saw chain chain chain chain Angle should not be too large, 30 degrees is appropriate.
3, before the use of chain saw, chain saw saw chain oil will be listed, the advantage is the ability to provide lubrication for the chain saw, reduce the chain saw saw chain and chain saw guide of the friction heat, protect the guide, at the same time also can protect the chain saw saw chain, so as to avoid premature discard.
4. When the saw is finished, the saw should also be maintained, so that the working efficiency can be guaranteed when the saw is used again.
The first is to remove impurities in the inlet hole and the guide slot at the bottom of the guide plate of the saw to ensure the smooth inlet hole.
Secondly, the guide plate head should be clear about the debris, and add a few drops of oil.
Finally, the oil saw is a two-stroke power, which should be paid attention to from the aspects of power and cutting tool, so as to ensure the normal use of the machine.
Engine for two-stroke engine, the use of fuel oil for gasoline mixed with oil, mixed oil ratio of special oil for two stroke: gasoline = 1:50, normal oil: gasoline = 25, you must pay attention to in the process of the use of chain saw these problems.