Home > Knowledge > Content

What's the reason that the saw can't start?

- Oct 13, 2018 -

What's the reason that the saw can't start?

003

1. Check the oil circuit and circuit to see whether the oil filter is blocked, whether the carburetor pumps oil normally, and whether the spark plug has electricity. Remove the spark plug and put it on the metal.
Remove the air filter and check if it is clean.
Remove the carburetor and drop a few drops of oil into the cylinder before starting the machine.
If not, clean the carburetor or replace it with a new one, and finally check the cylinder.
Tell everyone a method of maintaining the machine. If you do not use the machine for a long time, remember to pour out the oil from the oil tank.
Start the machine to burn the carburetor and cylinder oil, so as not to clog the carburetor with residual oil, usually clean air filters, lube must use better lubrication.
What about the oil spill from the saw?
What's the reason that the saw can't start?

Common problems in maintenance of oil saw
1. It is generally a problem of the filter if the oil saw turns off, does not work so hard and the generator overheats.
So before working, need to be checked to filter, clean and eligible filter is aimed at the sunlight to observe, should be thorough, bright, otherwise is unqualified.
When the filter of oil saw is not clean enough, use hot soapy water to clean, dry, clean filter can guarantee the normal use of oil saw.
2. When the saw teeth of oil saw become not sharp, you can use a special file to repair the serrated chain teeth to ensure the sharpness of the serrated teeth.
At this time, it should be noted that the direction of the file, along the cutting teeth, do not reverse, and file and oil saw chain chain Angle should not be too large, 30 degrees is appropriate.

3. Before using the oil saw, the oil of the chain saw should be added. The advantage of this method is that it can provide lubrication for the oil saw, reduce the friction heat between the chain of the oil saw and the guide plate of the oil saw, play a protective role for the guide plate, and also protect the chain of the oil saw from premature scrapping.

016

4. After the use of the saw, the saw should be maintained, so that the working efficiency can be guaranteed when the saw is used again.
The first thing is to remove impurities from the inlet hole and the groove of the guide plate of the oil saw to ensure a smooth inlet hole.
Next to the guide head should also be cleared of debris, and a few drops of oil.

Quote from:toutiao.com

Related Industry Knowledge

Related Products

  • 58cc Gas Chainsaw with 56cm Bar
  • Most Powerful Gas Chain Saw
  • Carbide Tipped Gas Chain Saw
  • 58cc Petrol Powered Steel Chainsaw
  • 58cc Best Petrol Chainsaw
  • Homemade Petrol Oregon Chainsaw